Dell PowerEdge R940 EMC Installation and Service Manual - Page 47
SATA Settings, Viewing SATA Settings
View all Dell PowerEdge R940 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Option Description NOTE: This option is only available on certain stock keeping units (SKUs) of the processors. SST-Performance Enables you to reconfigure the processor using Speed Select Technology. Profile x2APIC Mode Enables or disables the x2APIC mode. This option is set to Enabled by default. Dell Controlled Turbo Controls the turbo engagement. Enable this option only when System Profile is set to Disabled. NOTE: Depending on the number of installed processors, there might be up to four processor listings. Dell AVX Scaling Technology Number of Cores per Processor Processor Core Speed Processor Bus Speed Processor n Enables you to configure the Dell AVX scaling technology. This option is set to 0 by default. Controls the number of enabled cores in each processor. This option is set to All by default. Specifies the maximum core frequency of the processor. Displays the bus speed of the processor. NOTE: Depending on the number of processors, there might be up to four processors listed. The following settings are displayed for each processor that is installed in the system: Option Description Family-ModelStepping Specifies the family, model, and stepping of the processor as defined by Intel. Brand Specifies the brand name. Level 2 Cache Specifies the total L2 cache. Level 3 Cache Specifies the total L3 cache. Number of Cores Specifies the number of cores per processor. Maximum Memory Specifies the maximum memory capacity per processor. Capacity Microcode Specifies the microcode. SATA Settings You can use the SATA Settings screen to view the settings of SATA devices and enable SATA and PCIe NVMe RAID mode on your system. Viewing SATA Settings To view the SATA Settings screen, perform the following steps: Steps 1. Power on, or restart your system. 2. Press F2 immediately after you see the following message: F2 = System Setup NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then restart your system and try again. 3. On the System Setup Main Menu screen, click System BIOS. Pre-operating system management applications 47