Dell PowerEdge R940 EMC Installation and Service Manual - Page 127
Removing the expansion card riser
![]() |
View all Dell PowerEdge R940 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Figure 75. Installing expansion card riser blank (right) Next steps Follow the procedure listed in After working inside your system on page 66. Removing the expansion card riser Prerequisites 1. Follow the safety guidelines listed in Safety instructions on page 65. 2. Follow the procedure listed in Before working inside your system on page 66. 3. Disconnect any cables connected to the expansion card. Steps 1. Lift the release lever until the connector on the riser disconnects from the connector on the processor expansion module (PEM). 2. Lift the riser away from the system. Installing and removing system components 127
![](/manual_guide/products/dell-poweredge-r940-emc-installation-service-manual-9de4cf2/127.png)
Figure 75. Installing expansion card riser blank (right)
Next steps
Follow the procedure listed in
After working inside your system
on page 66.
Removing the expansion card riser
Prerequisites
1.
Follow the safety guidelines listed in
Safety instructions
on page 65.
2.
Follow the procedure listed in
Before working inside your system
on page 66.
3.
Disconnect any cables connected to the expansion card.
Steps
1.
Lift the release lever until the connector on the riser disconnects from the connector on the processor expansion module (PEM).
2.
Lift the riser away from the system.
Installing and removing system components
127