Dell PowerEdge R940 EMC Installation and Service Manual - Page 142
Optional IDSDM or vFlash module, Removing the optional IDSDM module
![]() |
View all Dell PowerEdge R940 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
Figure 91. Installing the MicroSD card Next steps 1. Follow the procedure listed in After working inside your system on page 66. Optional IDSDM or vFlash module Removing the optional IDSDM module Prerequisites 1. Follow the safety guidelines listed in Safety instructions on page 65. 2. Follow the procedure listed in Before working inside your system on page 66. 3. If you are replacing the IDSDM module, remove the MicroSD cards. NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal. Steps 1. Locate the IDSDM module connector on the system board. To locate IDSDM module connector, see the System board jumpers and connectors section. 2. Holding the pull tab, lift the IDSDM module out of the system. 142 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r940-emc-installation-service-manual-9de4cf2/142.png)