Dell PowerEdge R940 EMC Installation and Service Manual - Page 154
Installing the system board
View all Dell PowerEdge R940 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
Figure 103. Removing system board Next steps Install the system board. Installing the system board Prerequisites 1. Follow the safety guidelines listed in Safety instructions on page 65. 2. Follow the procedure listed in Before working inside your system on page 66. Steps 1. Unpack the replacement system board assembly. CAUTION: Do not lift the system board by holding a memory module, processor, or other components. CAUTION: Take care not to damage the system identification button while placing the system board into the system. 2. Holding the system board handle and blue release pin, incline the system board and lower the system board into the system. 3. Slide the system board toward the back of the system until the release pin clicks into place. 154 Installing and removing system components