Dell PowerEdge T340 EMC Installation and Service Manual - Page 104
Control panel, Removing the control panel assembly
View all Dell PowerEdge T340 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Control panel Removing the control panel assembly Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure listed in Before working inside your system. Steps 1. Using the Phillips #2 screwdriver, remove the screw that secures control panel to the system. 2. Disconnect the control panel cable and the control panel USB cable from the system board. CAUTION: Do not use excessive force when removing the control panel cables as it can damage the connectors. 3. Slide the control panel out of the system. 4. To remove the information tag, perform the following steps: a. Locate and press the tabs on the information tag. b. Push the information tag out of the slot to remove it from the control panel. Figure 84. Removing the control panel assembly NOTE: Retain the information tag to replace it in the new control panel. Next steps 1. Replace the control panel assembly. Installing the control panel assembly Prerequisites Follow the safety guidelines listed in Safety instructions. Steps 1. Replace the blank information tag in the new control panel with the information tag retained from the old control panel. 104 Installing and removing system components