Dell PowerEdge T340 EMC Installation and Service Manual - Page 27
Network Settings, Viewing Network Settings, Network Settings screen details
View all Dell PowerEdge T340 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Option UEFI Boot Sequence Boot Options Enable/Disable Description Enables you to change the boot device order. Enables you to select the enabled or disabled boot devices. Network Settings You can use the Network Settings screen to modify UEFI PXE, iSCSI, and HTTP boot settings. The network settings option is available only in the UEFI mode. NOTE: BIOS does not control network settings in the BIOS mode. For the BIOS boot mode, the optional Boot ROM of the network controllers handles the network settings. Viewing Network Settings To view the Network Settings screen, perform the following steps: Steps 1. Power on, or restart your system. 2. Press F2 immediately after you see the following message: F2 = System Setup NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then restart your system and try again. 3. On the System Setup Main Menu screen, click System BIOS. 4. On the System BIOS screen, click Network Settings. Network Settings screen details The Network Settings screen details are explained as follows: About this task Option Description PXE Device n (n = Enables or disables the device. When enabled, a UEFI PXE boot option is created for the device. 1 to 4) PXE Device n Settings(n = 1 to 4) HTTP Device n (n = 1 to 4) Enables you to control the configuration of the PXE device. Enables or disables the device. When enabled, a UEFI HTTP boot option is created for the device. HTTP Device n Settings (n = 1 to 4) Enables you to control the configuration of the HTTP device. UEFI iSCSI Settings Enables you to control the configuration of the iSCSI device. Table 3. UEFI iSCSI Settings screen details Option Description iSCSI Initiator Name Specifies the name of the iSCSI initiator in IQN format. iSCSI Device1 Enables or disables the iSCSI device. When enabled, a UEFI boot option is created for the iSCSI device automatically. This is set to Enabled by default. PowerEdge T340 Pre-operating system management applications 27