Dell PowerEdge T340 EMC Installation and Service Manual - Page 93
Removing a cabled power supply unit
View all Dell PowerEdge T340 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Figure 73. Installing a redundant power supply unit Next steps 1. Connect the power cable to the PSU, and plug the cable into a power outlet. CAUTION: When connecting the power cable to the PSU, secure the cable to the PSU with the strap. NOTE: When installing, hot swapping, or hot adding a new PSU, wait for 15 seconds for the system to recognize the PSU and determine its status. The PSU redundancy may not occur until discovery is complete. The PSU status indicator turns green to indicate that the PSU is functioning properly. Removing a cabled power supply unit Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure listed in Before working inside your system. Steps 1. Disconnect all the power cables of the PSU from the system board and the drive backplane. 2. Remove the screw securing the PSU to the system and slide the PSU out of the PSU bay in the chassis. Installing and removing system components 93