Dell PowerEdge T440 EMC Installation and Service Manual - Page 114
Installing the MicroSD card
View all Dell PowerEdge T440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
Figure 68. Removing the MicroSD card NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal. Next steps 1. Follow the procedure listed in After working inside your system. 2. Install a MicroSD card. Installing the MicroSD card Prerequisites Follow the safety guidelines listed in Safety instructions. NOTE: To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup. NOTE: If reinstalling, ensure that you install the MicroSD cards into the same slots based on the labels you had marked on the cards during removal. Steps 1. Locate the MicroSD card connector on the IDSDM/vFlash module. Orient the MicroSD card appropriately and insert the contact-pin end of the card into the slot. To locate IDSDM/vFlash, see Jumpers and connectors. NOTE: The slot is keyed to ensure correct insertion of the card. 2. Press the card into the card slot to lock it into place. 114 Installing and removing system components