Dell PowerEdge T440 EMC Installation and Service Manual - Page 78
Removing a 2.5-inch drive from a 3.5-inch drive adapter
![]() |
View all Dell PowerEdge T440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Figure 33. Installing a drive into the drive carrier Removing a 2.5-inch drive from a 3.5-inch drive adapter Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Remove the 3.5-inch drive adapter from the 3.5-inch hot swappable drive carrier. NOTE: A 2.5-inch drive is installed in a 3.5-inch drive adapter, which is then installed in the 3.5-inch drive carrier. Steps 1. Using a Phillips #2 screwdriver, remove the screws from the side of the 3.5-inch drive adapter. 2. Remove the 2.5-inch drive from the 3.5-inch drive adapter. 78 Installing and removing system components
![](/manual_guide/products/dell-poweredge-t440-emc-installation-service-manual-c5db9fb/78.png)
Figure 33. Installing a drive into the drive carrier
Removing a 2.5-inch drive from a 3.5-inch drive adapter
Prerequisites
1.
Follow the safety guidelines listed in
Safety instructions
.
2.
Remove the 3.5-inch drive adapter from the 3.5-inch hot swappable drive carrier.
NOTE:
A 2.5-inch drive is installed in a 3.5-inch drive adapter, which is then installed in the 3.5-inch drive carrier.
Steps
1.
Using a Phillips #2 screwdriver, remove the screws from the side of the 3.5-inch drive adapter.
2.
Remove the 2.5-inch drive from the 3.5-inch drive adapter.
78
Installing and removing system components