Dell PowerEdge T440 EMC Installation and Service Manual - Page 62
Before working inside your system, Recommended tools, Optional front bezel, Removing the front bezel
View all Dell PowerEdge T440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
NOTE: It is recommended that you always use an antistatic mat and antistatic strap while working on components inside the system. CAUTION: To ensure proper operation and cooling, all bays in the system and system fans must be always populated with a component or a blank. Before working inside your system Prerequisites Follow the safety guidelines listed in Safety instructions on page 61. Steps 1. Turn off the system, including all attached peripherals. 2. Disconnect the system from the electrical outlet and disconnect the peripherals. 3. Lay the system on its side. 4. Remove the system cover. After working inside your system Prerequisites Follow the safety guidelines listed in Safety instructions on page 61. Steps 1. Install the system cover. 2. Place the system upright on a flat, stable surface. 3. Reconnect the peripherals and connect the system to the electrical outlet. 4. Turn on the attached peripherals and then turn on the system. Recommended tools You need the following tools to perform the removal and installation procedures: • Key to the bezel lock The key is required only if your system includes a bezel. • Phillips #1 screwdriver • Phillips #2 screwdriver • Torx #T30 screwdriver • Wrist grounding strap Optional front bezel Removing the front bezel Prerequisites Follow the safety guidelines listed in Safety instructions on page 61. Steps 1. Unlock the bezel by using the bezel key. NOTE: There are two bezel keys attached to the back of the bezel. 62 Installing and removing system components