Dell PowerEdge T440 EMC Installation and Service Manual - Page 145
Dell PowerEdge T440 Manual
![]() |
View all Dell PowerEdge T440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product. Steps 1. Power off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 2. Remove the system cover. 3. Move the jumper on the system board jumper from pins 2 and 4 to pins 4 and 6. 4. Install the system cover. The existing passwords are not disabled (erased) until the system boots with the jumper on pins 4 and 6. However, before you assign a new system and/or setup password, you must move the jumper back to pins 2 and 4. NOTE: If you assign a new system and/or setup password with the jumper on pins 4 and 6, the system disables the new password(s) the next time it boots. 5. Reconnect the system to its electrical outlet and power on the system, including any attached peripherals. 6. Power off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 7. Remove the system cover. 8. Move the jumper on the system board jumper from pins 4 and 6 to pins 2 and 4. 9. Install the system cover. 10. Reconnect the system to its electrical outlet and power on the system, including any attached peripherals. 11. Assign a new system and/or setup password. Jumpers and connectors 145
![](/manual_guide/products/dell-poweredge-t440-emc-installation-service-manual-c5db9fb/145.png)