Epson 8300NL User Manual - Page 94
Replacing the Lamp
UPC - 010343846029
View all Epson 8300NL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
note You can check how long the lamp has been in use (see page 96). Lamp life results will vary depending on environmental conditions and usage. Turn the projector off when not in use. Continuous 24-houra-day use may reduce the overall life of this product. warning Let the lamp cool fully before replacing it. In the unlikely event that the lamp has broken, small glass fragments may be present and should be removed carefully to avoid injury. Replacing the Lamp The projection lamp typically lasts from 2000 to 3000 hours, depending on the Brightness Control setting used (see page 64). Selecting the low brightness setting helps extend the lamp's life. It is time to replace the lamp when: ■ The projected image gets darker or starts to deteriorate. ■ The message LAMP REPLACE appears on the screen and the lamp warning light flashes orange. ■ The lamp warning light flashes red (the lamp is burnt out). Contact your dealer or call EPSON at (800) 873-7766 in the United States for a replacement lamp. Request part number V13H010L23. In Canada, please call (800) 463-7766 for dealer referral. Follow these steps to replace the lamp: 1. Turn off the projector. 2. When the power light stops flashing, unplug the power cord. 3. Let the projector cool for at least half an hour (if it has been on). The lamp is extremely hot immediately after use. 4. If the projector is mounted on the ceiling, remove the rear cover. Release tab to remove rear cover 94 Maintaining the Projector