Epson PowerLite 810p User Manual - Page 69
Maintaining and Transporting the Projector, Then lift up and remove it.
View all Epson PowerLite 810p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Follow these steps to replace the lamp: 1. Turn off the projector, wait for it to cool down (when the light stops flashing), then unplug the power cord. 2. Allow the projector to cool for at least half an hour (if it has been on). 3. Use a screwdriver to slide the latch and pop open the lamp cover. Then lift up and remove it. warning Let the lamp cool before replacing it. If the lamp breaks, handle the shards carefully to avoid injury. 4. Use a screwdriver to loosen the two silver screws holding the lamp in place. (You can't remove these screws.) Maintaining and Transporting the Projector 63
Maintaining and Transporting the Projector
63
Follow these steps to replace the lamp:
1.
Turn off the projector, wait for it to cool down (when the light
stops flashing), then unplug the power cord.
2.
Allow the projector to cool for at least half an hour (if it has been
on).
3.
Use a screwdriver to slide the latch and pop open the lamp cover.
Then lift up and remove it.
4.
Use a screwdriver to loosen the two silver screws holding the lamp
in place. (You can
’
t remove these screws.)
warning
Let the lamp cool before
replacing it. If the lamp
breaks, handle the shards
carefully to avoid injury.