Gateway E-2100 E-2100 User's Guide - Page 169

Troubleshooting You see a "Disk is full" error message ■ Delete unnecessary files on the diskette. ■ Try a different diskette. Occasionally diskettes are flawed and cannot be read by the diskette drive. ■ Run Error checking on the diskette. For more information, see "Checking the hard drive for errors" on page 68. If errors are detected and corrected, try using the diskette again. You see a "Non-system disk" or "Disk error" error message ■ Eject the diskette from the diskette drive, then press ENTER. ■ Make sure that the diskette you are using is IBM-compatible. The diskette drive LED is lit continuously ■ Remove the diskette from the drive. If the light stays on, try restarting your computer. ■ Open the computer case and make sure that the cables are connected correctly to the diskette drive and the system board. The red-striped edge of the data ribbon cable indicates Pin 1 and corresponds with Pin 1 on the diskette drive (typically on the side farthest from the power supply connection). If necessary, reverse one end of the cable, so the red-striped edge of the data ribbon cable faces Pin 1 on the diskette drive. Make sure that the pins are not bent or misaligned. For more information, see "Adding or replacing a CD, DVD, or diskette drive" on page 105 or "Adding or replacing a CD, DVD, or diskette drive" on page 128. File management A file was accidentally deleted If the file was deleted at a DOS prompt or in Windows while holding down the SHIFT key, the file cannot be restored. To restore files that were deleted in Windows: 1 Double-click the Recycle Bin icon. 2 Right-click the file you want to restore, then click Restore. The file is restored to the place where it was originally deleted from. www.gateway.com 163