HP Integrity rx2800 Smart Setup Scripting Toolkit Administrator's Guide 4.0 - Page 47

Table 6-2 hpacuscripting Warning Codes (continued) Warning Code Message Reason 4003 One or more controller Certain commands require that the controller be configured commands were skipped because before they can be sent to the controller. the controller is not configured 4004 Using Repeat function Some commands have been ignored because the Repeat parameter has been specified in the input file. Table 6-3 hpacuscripting Error Codes Warning Code 0 2053 2056 2059 2064 2817 2818 2819 2819 2821 2823 2824 2825 2826 2827 2828 2829 Message Reason - No error exists. The program completed successfully. Too many coinciding expansion, migration, or extension operations The new configuration requires more transformations than are possible at one time. For example, you cannot expand a logical volume and transform its RAID level at the same time. Controller does not support The controller does not support license key entry or deletion. license keys Invalid license key The entered license key is not a valid license key. Controller does not support The controller does not support SSP functions. SSP Invalid action The requested actions are invalid, for example, combining -reset with capture mode. Invalid Method The method must be either Custom or Auto. Controller '%s' is invalid The controller specified is not specified correctly. Invalid Controller An invalid controller value was specified. No controllers detected No controllers were detected. This error applies to Input mode only. Invalid Rebuild Priority The specified rebuild priority is not supported. Invalid Expand Priority The specified expand priority is not supported. This error also occurs if the controller does not allow expansion (does not support Expand Priority). Invalid Array The array ID is invalid. Array not specified The Array command is missing from the script file. Some commands were found that require an array to be specified. New Array ID does not match The array ID in the script file does not match the array ID of the the next available Array ID next available array. For example, if the configuration has Array A and the input file specifies Array C (without Array B), the script generates this error. New Array ID already exists When running in Configure mode, the array ID in the script file already exists in the configuration. Configure mode can only create new arrays. Cannot create Array The controller does not allow a new array to be created. Possible causes are there are no unassigned physical drives on the controller or the maximum number of arrays or logical drives has already been reached. hpacuscripting 47