HP ML115 HP ProLiant ML115 Generation 5 Server Maintenance and Service Guide - Page 35
Optical drive, Connect the power and data cables to the connectors on the rear of the drive.
UPC - 884962252765
View all HP ML115 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Figure 7 Releasing drives 3. When replacing drives, remove the four guide screws (two on each side) from the old drive. You will need these screws to install a new drive. Optical drive To install an optical drive: 1. Fasten four screws (two on each side) into the optical drive. 2. Slide the optical drive into the optical bay, with the cable connectors of the drive facing the rear of the chassis and then push the drive all the way into the drive bay until the drive clicks into place. 3. Connect the power and data cables to the connectors on the rear of the drive. Figure 8 Installing the optical drive To remove an optical drive: 1. Disconnect the power and data cables from the rear of the optical drive. Removal and Replacement Procedures 35
Removal and Replacement Procedures
35
Figure 7
Releasing drives
3.
When replacing drives, remove the four guide screws (two on each side) from the old drive. You
will need these screws to install a new drive.
Optical drive
To install an optical drive:
1.
Fasten four screws (two on each side) into the optical drive.
2.
Slide the optical drive into the optical bay, with the cable connectors of the drive facing the rear
of the chassis and then push the drive all the way into the drive bay until the drive clicks into
place.
3.
Connect the power and data cables to the connectors on the rear of the drive.
Figure 8
Installing the optical drive
To remove an optical drive:
1.
Disconnect the power and data cables from the rear of the optical drive.