HP ML115 HP ProLiant ML115 Generation 5 Server Maintenance and Service Guide - Page 56

Power supply unit (PSU), To remove the power supply

Get HP ML115 - ProLiant - G5 PDF manuals and user guides
UPC - 884962252765
View all HP ML115 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 56 highlights

Figure 40 Installing the system board Power supply unit (PSU) Located on the rear panel of the server power supply is a single standard auto-range 365-watt PSU with PFC (power factor correction) function. WARNING: Note the following reminders are to reduce the risk of personal injury from electric shock hazards and/or damage to the equipment. • Installation of power supply unit should be referred to individuals who are qualified to service server systems and are trained to deal with equipment capable of generating hazardous energy levels. • DO NOT open the power supply unit. There are no serviceable parts inside it. To remove the power supply: NOTE: Lay the server on its side with the open side facing up. 1. Disconnect the power cables of all installed drives from the power supply. 2. Remove the four screws that secure the power supply to the chassis. 3. Lift the power supply out of the chassis. Removal and Replacement Procedures 56

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
Removal and Replacement Procedures
56
Figure 40
Installing the system board
Power supply unit (PSU)
Located on the rear panel of the server power supply is a single standard auto-range 365-watt PSU
with PFC (power factor correction) function.
WARNING:
Note the following reminders are to reduce the risk of personal injury from electric
shock hazards and/or damage to the equipment.
•
Installation of power supply unit should be referred to individuals who are qualified to service server
systems and are trained to deal with equipment capable of generating hazardous energy levels.
•
DO NOT open the power supply unit. There are no serviceable parts inside it.
To remove the power supply:
NOTE:
Lay the server on its side with the open side facing up.
1.
Disconnect the power cables of all installed drives from the power supply.
2.
Remove the four screws that secure the power supply to the chassis.
3.
Lift the power supply out of the chassis.