HP StorageWorks MSA1510i HP StorageWorks 1510i Modular Smart Array installatio - Page 127
Module Missing, Module Detected
View all HP StorageWorks MSA1510i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Message 522 INITIALIZING ISCSI SUBSYSTEM Type Informational 523 LOADING ISCSI PARAMS Informational 524 ISCSI MODULE HARDWARE FAILURE Error 525 ISCSI MODULE BIST FAILED Error 526 ETHERNET MODULE DETECTED Informational 527 ETHERNET MODULE MISSING Error 528 ETHERNET MODULE INVALID Error 600 INITIALIZING TARGET-BASED MGMT Informational 601 PORT LINK FAILURE 602 PORT LINK OK Mb/s Error Informational 603 PORT IP Informational 604 PORT DHCP FAILED Error 605 MANAGEMENT PORT ENABLED Informational 606 MANAGEMENT PORT DISABLED Informational 607 NO MANAGEMENT HARDWARE FOUND Error Description Action The iSCSI subsystem is being initialized as part of the power-on sequence. The iSCSI configuration is being loaded into the iSCSI hardware as part of the power-on sequence. The array controller has detected a hardware failure in the iSCSI daughter board. Contact HP support. The iSCSI daughter board has detected a failure during its Built In Self Test (BIST). Contact HP support. A 2-Port Ethernet iSCSI module has been inserted or detected during POST. No 2-Port Ethernet iSCSI module was detected during POST. Network connectivity is unavailable. Insert a 2-Port Ethernet iSCSI module into the appropriate slot in the rear of the chassis. The module in the Ethernet module bay is not a valid 2-Port Ethernet iSCSI module, or the module has failed. Verify that the module is inserted properly into the bay. If the problem persists, replace the module. The Target-Based Management subsystem is being initialized as part of the power on sequence. The MSA has detected a link Check the network cable attached failure on the indicated GBE port. to the port. The MSA has detected an active link on the indicated GBE port. The management IP address on the indicated port has been changed, and the new address is displayed for user reference. The MSA has failed to obtain an IP address for the management port via DHCP, and will fall back to zeroconf IP address. Check that a DHCP server exists on your network, or reconfigure Target-Based Management to use a static IP address. The MSA has enabled management access through the indicated port as part of the power on sequence or due to a hardware failure on the configured port. The MSA has disabled management access through the indicated port. The array controller is unable to locate any Ethernet hardware that can be used to provide management access. Target-Based Management functionality is disabled. Contact HP support. 1510i Modular Smart Array installation and user guide 127