HP StorageWorks MSA1510i HP StorageWorks 1510i Modular Smart Array installatio - Page 46
Installing hard drives in the enclosures, located on the Manuals of the MSA1510i support website
![]() |
View all HP StorageWorks MSA1510i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Installing hard drives in the enclosures After the storage enclosures are secured in the rack, install hard drives into the drive bays. For installation instructions, see the documents shipped with the hard drive or enclosure. Be sure to record information about the hard drives and their configuration (Array and unit information, Target information, and Initiator access information) For a list of the hard drives that are supported for use with the MSA1510i and your storage enclosure, read the MSA1510i compatibility guide, located on the Manuals page of the MSA1510i support website: http://www.hp.com/support. CAUTION: • Follow industry-standard practices when handling hard drives. Internal storage media can be damaged when drives are shaken, dropped, or roughly placed on a work surface. • When installing a hard drive, make sure the drive is fully seated in the drive bay. • When removing a hard drive, press the release button and pull the drive only slightly out of the enclosure. Then, to allow time for the internal disk to stop rotating, wait approximately 10 seconds before completely removing the drive from the enclosure. NOTE: HP recommends installing hard drives in bay-number sequence. Locate this and additional installation information in the documentation shipped with the storage enclosure. newpage pi 46 Installation
![](/manual_guide/products/hewlettpackard-storageworks-1510i-hp-storageworks-1510i-modular-smart-array-installation-user-guide-383070002-2008-1efa5c4/46.png)