HP Tc4100 hp server tc4100 operation and maintenance guide (English, 2.1) - Page 40
Selecting SCSI Tape Drives, R1 and R2, P2 and P3 - server drive
![]() |
View all HP Tc4100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Chapter 3 Installing and Configuring 10. Connect the power cable and the appropriate data cable (SCSI) from the system board or SCSI controller to the device. 11. The air flow guide, the fan assembly, and the fan cage may need to be removed to access the back of the drive cage to connect the drive data and power cables. 12. Replace the cover(s) and front bezel. 13. If the Server is rack mounted, slide it back into the rack and secure it. 14. Return power to the Server and run the Setup Utility to configure the device. Selecting SCSI Tape Drives NOTE Tape drives do not come with the mounting hardware that is required for installation. Be sure to order the appropriate mounting kit (HP product number Q1447A). Table 3-2 lists the supported tape drive models with their respective part number, size (half height or full height), and the Hp Server location in which the tapes are supported. Figure 3-12 displays linear drawings of the HP Server tc4100 rack and pedestal versions with the locations for the different SCSI Tape Drive models. UseFigure 3-12 to match the codes on the "Supported Location" column of Table 3-2. Table 3-2. SCSI Tape Drives Specification DRIVE DLTVS 80i Size Part No. Half Height C7405A Supported Location R1 or R2, P2 or P3 DAT 40i Half Height C56864A R1 or R2, P2 or P3 Ultrium 215i Half Height C7420A R1 or R2, P2 or P3 DAT 24i Half Height C1555D R1 or R2, P2 or P3 DAT 24x6i Full Height C5677B Ultrium 230i Full Height C7400A R1 and R2, P2 and P3 (Two HH slots are required) R1 and R2, P2 and P3 (Two HH slots are required) DAT 40x6i Full Height C5677A R1 and R2, P2 and P3 (Two HH slots are required) Comments Use the plastic drive rails when installing. Use the plastic drive rails when installing. Use the metal drive rails when installing on the server. Use the metal drive rails when installing on the server. Use the metal drive rails when installing on the server. If this drive is installed in position P2 or P3, it is necessary to remove the power protection bracket of the server. Drive will extend slightly from the front of the server. Use the metal drive rails when installing on the server. If this drive is installed in position P2 or P3, it is necessary to remove the power protection bracket of the server. Use the metal drive rails when installing on the server. 38
![](/manual_guide/products/hewlettpackard-tc4100-hp-server-tc4100-operation-maintenance-guide-english-21-e29869f/40.png)