HP Xw8200 HP Workstation xw8200 Service and Technical Reference Guide (Complet - Page 134
POST Error Messages Continued, Screen Message, Probable Cause, Recommended Action
UPC - 882780210455
View all HP Xw8200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
Table 5-18 POST Error Messages (Continued) Screen Message Probable Cause Recommended Action 162-System Options Not Set Configuration incorrect. RTC battery might need to be replaced. 1 Run Computer Setup (F10 Setup). 2 Set the date and time under Control Panel or in F10 Setup depending on the operating system. 3 If the problem persists, replace the RTC battery. 163-Time and Date Not Set Invalid time or date in configuration memory. RTC (real-time clock) battery might need to be replaced. CMOS jumper might not be properly installed. 1 Set the date and time under Control Panel or in F10 Setup depending on the operating system. 2 If the problem persists, replace the RTC battery. 164-Memory Size Error Memory configuration is incorrect. 1 Run Computer Setup (F10 Setup) or Windows utilities. 2 Be sure memory module(s) (if any) are installed properly. 3 If third-party memory has been added, test using HP-only memory. 4 Verify proper memory module type. 183-Invalid Processor Jumper Setting System board jumper improperly set. Reset system board jumpers to match processor and bus speeds (select models). 201-Memory Error RAM failure. 1 Run Computer Setup (F10 Setup) or Windows utilities. 2 Be sure that memory and continuity modules are installed correctly. 3 Verify proper memory module type. 4 Remove and replace memory module(s) one at a time to isolate faulty module. 5 Replace the faulty memory module(s). 6 If error persists after replacing memory modules, replace the system board. 202-Memory Type Mismatch Memory modules do not match each Replace memory modules with matched sets. other. 207-ECC Corrected Single Single Bit ECC error. Bit Errors in Memory Socket(s) y,y 1 Verify proper memory module type. 2 Try another memory socket. 3 Replace memory module if problem persists. 212-Failed Processor Processor has failed to initialize. 1 Reseat the processor in its socket. 2 If the processor does not respond, replace it. 213-Incompatible memory Module in memory Socket(s) X,X, X A memory module in memory socket 1 Verify proper memory module type. identified in the error message is missing critical SPD information, or is 2 Try another memory socket. incompatible with the chipset. 3 Replace memory with a module conforming to the SPD standard. 134 SYSTEM DIAGNOSTICS AND TROUBLESHOOTING