HP Xw8200 HP Workstation xw8200 Service and Technical Reference Guide (Complet - Page 99
Processor, Removing the Processor
UPC - 882780210455
View all HP Xw8200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Chapter 4 5 Screw in the four CPU heatsink screws. First, tighten all of the screws partially so that the CPU heatsink remains level. Next, fully tighten one pair of diagonally opposite screws 1 then fully tighten the remaining pair 2. Tighten firmly to a torque setting of 6 in-lbs. 1 2 2 1 6 Connect the CPU heatsink fan connector to the system board. Processor Removing the Processor 1 Disconnect power from the system (page 66), remove the access panel (page 71), and remove the CPU heatsink (page 96). 2 Raise the processor socket handle fully (the full swing angle of the lever is approximately 135 degrees). REMOVAL AND REPLACEMENT OF COMPONENTS 99
REMOVAL AND REPLACEMENT OF COMPONENTS
99
Chapter 4
5
Screw in the four CPU heatsink screws. First, tighten all of the screws partially so that the CPU
heatsink remains level. Next, fully tighten one pair of diagonally opposite screws
1
then fully tighten
the remaining pair
2
. Tighten firmly to a torque setting of 6 in-lbs.
6
Connect the CPU heatsink fan connector to the system board.
Processor
Removing the Processor
1
Disconnect power from the system (
page 66
), remove the access panel (
page 71
), and remove the
CPU heatsink (
page 96
).
2
Raise the processor socket handle fully (the full swing angle of the lever is approximately 135
degrees).
1
1
2
2