HP Xw8400 HP xw8400 Service and Technical Reference Guide - Page 83
PCI retention clamp,
![]() |
UPC - 883585271085
View all HP Xw8400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
2. For short or tall PCI cards, attach the hooks of the PCI retainer (1) under the slots on the rear of the chassis, and then rotate the retainer down until the retainer arm (2) supports the card. Figure 4-19 Installing the short or tall card PCI retainer PCI retention clamp 1. Disconnect power from the system ( Pre-disassembly procedures on page 55), and remove the access panel (Access panel on page 60). Place the workstation on its side with the system board facing up. 2. Open the PCI retention clamp by pressing down on the two green clips at the ends of the clamp and rotating the clamp toward the back of the system. Figure 4-20 Opening the PCI retention clamp ENWW Removing and replacing components 73
![](/manual_guide/products/hewlettpackard-xw8400-hp-xw8400-service-technical-reference-guide-1cc1199/83.png)
2.
For short or tall PCI cards, attach the hooks of the PCI retainer
(1)
under the slots on the rear of
the chassis, and then rotate the retainer down until the retainer arm
(2)
supports the card.
Figure 4-19
Installing the short or tall card PCI retainer
PCI retention clamp
1.
Disconnect power from the system (
Pre-disassembly procedures
on page
55
), and remove the
access panel (
Access panel
on page
60
). Place the workstation on its side with the system board
facing up.
2.
Open the PCI retention clamp by pressing down on the two green clips at the ends of the clamp
and rotating the clamp toward the back of the system.
Figure 4-20
Opening the PCI retention clamp
ENWW
Removing and replacing components
73