HP d248 HP Compaq Business Desktop d200 Series Personal Computers Service Refe - Page 50
Removing a 5.25\, Preparation for Disassembly, Access Panel, Front Bezel
View all HP d248 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Removal and Replacement Procedures- Microtower Type 2 Chassis 6.7.2 Removing a 5.25" Drive 1. Prepare the computer for disassembly (Section 6.1, "Preparation for Disassembly"). 2. Remove both the right and left access panels (Section 6.2, "Access Panel"). 3. Remove the front bezel (Section 6.3, "Front Bezel"). 4. Disconnect the power, data, and audio cables, as necessary, from the back of the drive. ✎ In some cases it may be easier to slide the drive part way out of the drive bay before removing the cables. 5. Remove the four screws, two from each side, that secure the drive in the drive cage 1. 6. Slide the drive out of the drive cage 2. To install a drive, reverse the removal procedure. ✎ If you are installing a 5.25" drive for the first time into bay 2 you must first remove the drive from bay 1 and then knock or pry out the metal shield that covers the front of bay 2. Å WARNING: There may be sharp edges on the inside of the bay opening after the shield has been removed. 6-10 336493-004 Service Reference Guide, d200