IBM 6500-V5P Maintenance Manual - Page 136

Operator Panel Message 191 SECURITY VIOLATION 194 INCOMPAT. E-NET NIC REPLACE NIC Display Messages Table 3. Message List Explanation Corrective Action Security code of the security key on the controller board does not match the code of the firmware on the controller board. The ethernet NIC installed in the printer is not the correct part number for a 6500-v printer. 1. Power off and unplug the printer. Remove the paper guide assembly or pedestal top cover. Check the security key at connector J9 on the controller board. The security key is a 3-pin jumper connector. If it is absent, install the correct key for the customer's emulations. If a key is present, replace it. 2. Plug in the printer and power it on. If the message appears, the controller board or microcode is suspect. Do the following: 3. Save the printer configuration values. (Refer to the User's Manual.) 4. Clear NVRAM (page 237). 5. Download and install the latest code from IBM First (page 231). 6. Power on the printer in download mode and load flash memory (page 238). a. If you encounter loading problems, go to the appropriate error code for resolution. b. If you encounter the failure or message that brought you to this procedure, replace the controller board (page 319). After replacing the controller board, DO NOT make the printer READY, but proceed immediately to the next step. 7. Download and install the latest code from IBM First (page 231). 8. Power on the printer in download mode and load flash memory (page 238). 9. If you encounter the failure after replacing the controller board, reinstall the original controller board and contact your DDS and Second Level Support. Remove the NIC and replace it with a NIC with the correct part number for this printer. 136