IBM 6500-V5P Maintenance Manual - Page 75
Harness Test Tables in Replace components that fail, INTAKE FAN CHECK, SEE USERS MANUAL
View all IBM 6500-V5P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Operator Panel Message 083 INTAKE FAN CHECK * SEE USERS MANUAL Display Messages Table 3. Message List Explanation Corrective Action Sensors cannot detect current in the card cage fan circuit. 1. Cycle power. If the message appears, press STOP. 2. Power off and unplug the printer. Remove the paper guide assembly or pedestal top cover. Verify that connector p106/CCF is not installed backwards. The side of the connector with the locking tab MUST point toward the shell (i.e., outward) when it is plugged into P106. If it is backwards, the fan will not run and the 083 error will appear. 3. Disconnect connector P106 from the controller board. Test connector P106/CCF for shorts or opens. (Refer to the Main Wire Harness Test Tables in Chapter 3.) Replace components that fail test. 4. Make sure P106/CCF has a good connection at J106 on the controller board. 5. Inspect for obstructions of airways and vents. 6. Check the shuttle for electrical shorts (page 252). 7. Plug in the printer and power it on. If the problem reappears, the controller board or microcode is suspect. Do the following: 8. Save the printer configuration values. (Refer to the User's Manual.) 9. Clear NVRAM (page 237). 10. Download and install the latest code from IBM First (page 231). 11. Power on the printer in download mode and load flash memory (page 238). a. If you encounter loading problems, go to the appropriate error code for resolution. b. If you encounter the failure or message that brought you to this procedure, replace the controller board (page 319). After replacing the controller board, DO NOT make the printer READY, but proceed immediately to the next step. 12. Download and install the latest code from IBM First (page 231). 75