IBM 6500-V5P Maintenance Manual - Page 216

Selecting And Running Tests Customer Engineer (CE) Tests A set of printer tests is included in the configuration menu structure for use as maintenance tools. These are called "Customer Engineer Tests" (CE Tests) because they are for your use; they are not available to the user through his documentation. You will use these tests in various troubleshooting and adjustment procedures. CE tests do not run at the rated speed of the printer. CE Tests NOTE: * = Default Value NOTE: ENTER key to move down SCROLL ↑ to move to next item SERVICE PRINTER MECHANISM TESTS SERVICE HAMMER PHASE VALUE SERVICE END OF FORMS ADJUST VAL SERVICE IPDS DEMOS SERVICE MEMORIZE IPDS DEMO SERVICE * SET COIL TEMPERATURE Burn In Test Plot Test Shuttle Only Shuttle Slow Shuttle Fast Hammer Phasing End of Forms Adjust 1 -1000 NOTE: Value is a numeric unit only. This test is defined on page 218. Procedure on page 381. 4 - 76, 40 DOTS* Unit of dot measurement is dot rows. Procedure on page 378. Slot 1 ... to ... Slot 8 in increments of 1, then Start Demo (On printers using IPDS emulation.) DISABLE* ENABLE (On printers using IPDS emulation.) * 6500-v15 and -v20 printers only. (Procedure on page 383.) SERVICE SELECT CT TYPE SERVICE UPGRADE NETWORK ADAPTER SERVICE PRINTER MGMT SERVICE C/T DATA TIMEOUT SERVICE ENERGY SAVER TIMER SERVICE DEMO COUNT ENTER STANDARD* SIMPLE PROTOCOL (On printers with CT installed) ENTER Printer reads and upgrades adapter settings. (On printers with external NIC adapter.) 3 to 9 seconds in 1 second increments (On printers with CT installed) ENABLE* DISABLE Demo Count 1 * 2 5 10 Continuous PRINTER MGMT Debug Port Cfg PRINTER MGMT Serial PRINTER MGMT Clear Password PRINTER MGMT Reboot w/Factory PRINTER MGMT MANAGER PORT NO. PRINTER MGMT PORT TIMEOUT PRINTER MGMT DEBUG ACCESS PRINTER MGMT ADAPT TO DEFAULT A Go to next page B Go to next page Done ENTER ENTER Printer reboots with Factory configuration. 3001* Range: 1023 to 65535 in increments of 1 100 SECONDS * Range: 1 to 255 seconds in increments of 1 ENTER ENABLE * NO TELNET DEBUG (On printers with external NIC adapter.) Figure 7. This figure shows the menu structure of the Customer Engineer Tests. PRINTER MGMT E-NET TO DEFAULT ENTER (On printers with PCI NIC.) 216