IBM 6500-V5P Maintenance Manual - Page 34

Controls And Indicators Electrical Controls: Figure 5 Electrical Controls: Figure 5 Key or Indicator MENU CONFIG RETURN MICRO ↑ MICRO ↓ SCROLL ↑ SCROLL ↓ ENTER LINE FEED VIEW FORM FEED SET TOP OF FORM CANCEL EJECT STOP Function If the printer is in NOT READY mode, this key puts the printer into PROGRAM mode. If the configuration menus are locked, the LCD indicates the operator panel is locked. Prints the current configuration. Returns to the next higher level of a configuration menu. In NOT READY mode, moves the paper upward 1/72 inch ("micro-step" function). In NOT READY mode, moves the paper downward 1/72 inch ("micro-step" function). In PROGRAM mode, moves to the next menu ("Scroll" function). In PROGRAM mode, moves to the previous menu ("Scroll" function). Selects the option displayed on the LCD. This action either sets a value, moves to the next lower level of configuration, or starts a self-test. Moves paper up one line, as determined by current line spacing. Press to move the current print position up to the tractor area for viewing. Press again to return paper to original print position. Advances paper to next Top-Of-Form, as defined by the current page length. Sets Top-Of-Form and moves paper downward from the tractor alignment notches to the print position. Cancels a print job. Moves paper for viewing or tear-off. This key is configurable: refer to the User's Manual. Puts the printer in NOT READY mode. This key also stops a Printer Test, and restores after an eject. 34