IBM 6500-V5P Maintenance Manual - Page 139

Operator Panel Message 306 UNKNOWN RIBBON INSTALL NEW IBM RIBBON 307 UNKNOWN RIBBON INSTALL NEW IBM RIBBON 308 RIBBON SENSOR ERROR SEE USERS MANUAL 990 MACHINE CHECK A97 GRAPHIC CHECK ERROR PRESS STOP THEN START B00 STATUS: SDRAM DETECTION 33MHZ B01 STATUS: 8245 SDRAM TEST 32MB B10 ERROR: NO DRAM DETECTED* B11 ERROR: RAM TEST FAILED* B12 ERROR: PROGRAM MISSING* B13 ERROR: NOT COMPATIBLE* Display Messages Table 3. Message List Explanation Corrective Action The sensor detects a bar code, but the OEM ribbon model is not permitted on this printer. The sensor detects a bar code, but the region code does not match the printe A future enhancement not supported on this printer. Host status message. The printer received a nonprintable character over a twinax interface. Status message: the printer has begun its boot-up initialization routines and is checking for the presence of SDRAM. Status message: printer boot-up routines are testing SDRAM. Boot-up routines did not detect the presence of the SDRAM DIMM. SDRAM failed the boot initialization test. The printer does not see a program in flash memory. The printer is not compatible with the downloaded program. Install a new IBM ribbon. Install a new IBM ribbon. No action required. No action required. Press STOP then START. No action required. No action required. Cycle power. If the message appears, replace the controller board. Record the message and return it with the defective board. Cycle power. If the message appears, replace the controller board (page 319). Record the message and return it with the defective board. There is no program in printer memory. Download an emulation. Load the correct emulation software option(s) for this printer. 139