IBM 6500-V5P Maintenance Manual - Page 137

Operator Panel Message 195 INCOMPAT. WLAN NIC REPLACE NIC 200 SOFTWARE ERROR* RECYCLE POWER Display Messages Table 3. Message List Explanation Corrective Action The wireless NIC installed in the printer is not the correct part number for a 6500-v printer. Application software tried to perform an illegal printer function or damaged logic circuits were detected on the controller board. Remove the NIC and replace it with a NIC with the correct part number for this printer. 1. Cycle power. If the message appears, power off and unplug the printer. 2. Disconnect the input data line from the host computer. Plug in the printer and power it on. If the message appears, download the latest code from IBM First (page 231). 3. Cycle power. Run the print job again. If the message reappears, the controller board or microcode is suspect. Do the following: 4. Save the printer configuration values. (Refer to the User's Manual.) 5. Clear NVRAM (page 237). 6. Download and install the latest code from IBM First (page 231). 7. Power on the printer in download mode and load flash memory (page 238). a. If you encounter loading problems, go to the appropriate error code for resolution. b. If you encounter the failure or message that brought you to this procedure, replace the controller board (page 319). After replacing the controller board, DO NOT make the printer READY, but proceed immediately to the next step. 8. Download and install the latest code from IBM First (page 231). 9. Power on the printer in download mode and load flash memory (page 238). 10. If you encounter the failure after replacing the controller board, there is an application software error. Reinstall the original controller board and contact your DDS and Second Level Support. 137