IBM 86607SU Hardware Maintenance Manual - Page 156

Before you begin, be sure you have: Read "Safety information" on page 308 Followed any special handling and installation instructions supplied with the replacement battery. Note After you replace the battery, you must reconfigure the server and reset the system date and time. To replace the battery: 1. Turn off the server and peripheral devices and disconnect all external cables and power cords (see "Preparing to install options" on page 220); then remove the top cover (see "Top cover removal" on page 262). 2. Locate the battery on the system board (see "System board component locations" on page 255). 3. Remove any adapters that are installed in PCI slots 1 and 2, so you can access the battery. (See "Hot-plug PCI adapter installation" on page 173 for information about installing and removing adapters from the hot-plug PCI slots.) 4. Lift and remove the plastic dividers between PCI slot 1 and the ISA slot and between PCI slot 1 and PCI slot 2 by pressing the latches on the top ends of the dividers toward the dividers and lifting the dividers from the server. 5. Remove the battery: a. Use one finger to lift the battery clip over the battery. b. Use one finger to slightly slide the battery toward the rear of the server. The spring mechanism behind the battery will push it out toward you as you slide it forward. c. Use your thumb and index finger to pull the battery from under the battery clip. d. Ensure that the battery clip is touching the base of the battery socket by pressing gently on the clip. 6. Insert the new battery: a. Tilt the battery so that you can insert it into the front of the socket, under the battery clip. b. As you slide it under the battery clip, press the battery down into the socket. 148 Netfinity Server HMM