IBM 86607SU Hardware Maintenance Manual - Page 217
Installing devices in the NetBAY3, General considerations
UPC - 087944501329
View all IBM 86607SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 217 highlights
Installing devices in the NetBAY3 This appendix contains information about installing devices in the NetBAY3. Note The illustrations in this appendix do not show the server on top of the NetBAY3, however, you do not need to remove the NetBAY3 to install devices. General considerations: You can install three types of devices in the NetBAY3: Devices, such as the IBM EXP10, that sit on side rails Cantilevered devices, such as a power distribution unit (PDU), that are screwed to the front or rear of the NetBAY3 Devices that sit on the NetBAY3 base plate Notes 1. To allow the NetBAY3 front bezel to close, devices with handles must not protrude out more than 56 cm (2.2 in.). The following illustration of the front bezel top-view cross section shows the clearances. 2. All device cables must exit from the rear of the NetBAY3. 56 mm (2.2 in.) 30 mm (1.2 in.) Netfinity 5500 - Type 8660 209