IBM 86607SU Hardware Maintenance Manual - Page 194
supply is in the On position., Verify that the ac Power light
![]() |
UPC - 087944501329
View all IBM 86607SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 194 highlights
c. Grasp the handle 5 on the power supply and pull the handle toward the center of the server; then, slide the power supply out of the chassis. Note During normal operation, each power-supply bay should have either a power supply or filler panel installed for proper cooling. 4. If you are not installing a replacement power supply: a. Disconnect the power cord for the power supply that you replaced. b. Install a power-supply filler panel; then go to step 5. If you are replacing the power supply: a. Place the handle 5 on the power supply in the open position, and slide the power supply into the chassis. b. Gently close the handle 5 on the power supply to seat the power supply in the bay. c. Make sure the Power switch 6 on the power supply is in the On position. d. Verify that the ac Power light 7 and dc Power light 8 are lit, indicating that the power supply is operating correctly. Caution When the power-cord strain-relief bracket option is installed on the power cord, the server must be plugged to a power source that is easily accessible. e. Install a power-cord strain-relief bracket 1 , if desired. 5. If you have other options to install or remove, do so now; otherwise, go to "Completing the installation" on page 154. 186 Netfinity Server HMM
![](/manual_guide/products/ibm-866011u-hardware-maintenance-manual-12f5559/194.png)