IBM 86607SU Hardware Maintenance Manual - Page 211

9. Pull the shuttle 7 toward the back of the server. 10. Connect one of the connectors on the SCSI cable for the removable-media drive bays 6 to the back of the drive 5 . 11. Connect a power cable to the back of the drive. Power cables for removable-media drives come installed in the server. The connectors are keyed and can be inserted only one way. 12. If you are installing another 5.25-inch drive, do so at this time. Otherwise, continue with the next step. 13. Push the shuttle 7 toward the front of the server and tighten the four thumbscrews 8 at the back of the shuttle. 14. Install the media-bay trim bezel and the NetBAY3 bezel that you removed earlier. (See "Installing the trim bezels and server door" on page 156) 15. If you have other options to install or remove, do so now; otherwise, go to "Completing the installation" on page 154. Installing a drive in a hot-swap bay: The bays on the right front of the server support hot-swap drives only. Note You do not have to turn off the server to install hot-swap drives in these bays. However, you must turn off the server when performing any steps that involve installing or removing cables. Before you begin: Read "Safety information" on page 308. Read the documentation that comes with the drive. Reviewed "ServeRAID Configuration program" on page 74. for information about the RAID controller and disk-array configuration. Prepare the drive for installation (see "Preinstallation steps (all bays)" on page 200). Refer to the following illustration while you perform the steps in this procedure. Netfinity 5500 - Type 8660 203