IBM 86607SU Hardware Maintenance Manual - Page 210

5 Drive 6 SCSI cable for the removable-media drive bays 7 Shuttle 8 Thumbscrews To install a removable-media drive in one of the left front bays: 1. Turn off the server and peripheral devices (see "Preparing to install options" on page 220) and remove the top cover (see "Top cover removal" on page 262). 2. Remove the NetBAY3 bezel and the media-bay trim bezel. (See "Server door and trim bezels removal" on page 252.) 3. Remove the screws 1 and filler panel 2 from the bay opening. Save screws for later use in this procedure. You do not need the filler panel when you have a drive installed in the bay. 4. Touch the static-protective bag containing the drive to any unpainted metal surface on the server; then, remove the drive from the bag and place it on a static-protective surface. 5. Set any jumpers or switches on the drive according to the documentation that comes with the drive. 6. Use screws 4 of the appropriate size and length to attach a slide rail 3 to each side of the drive 5 . Note The slide rails and screws are included in the drive accessory kit that comes with the server. 7. Place the drive so that the slide rails engage in the bay guide rails. Push the drive into the bay and attach it with the two screws 1 from the filler panel. 8. Loosen the four thumbscrews 8 on the shuttle at the back of the server. 202 Netfinity Server HMM