IBM 86607SU Hardware Maintenance Manual - Page 31

4. Continue with "Using the Server Utility Programs" on page 23. From a client workstation on the network: 1. Insert the IBM ServeRAID Device Driver Diskette into a diskette drive, such as drive a:. 2. Type: copy a:\remote\servers\netware\ipsadm.nlm f:\system\ipsadm.nlm (where a: is the diskette drive letter and f is the SYS volume) 3. Load the NLM from the system console. Type: load ipsadm.nlm 4. Continue with "Using the Server Utility Programs." SCO OpenServer Server Utility Program: The SCO OpenServer Server utility program is installed from the SCO Open Server Boot-Time Loadable (BTLD) Diskette during the installation of the IBM ServeRAID device driver. The file is installed in the /usr/bin directory. To run the program, type ipsadm & at the command prompt. If the program does not run, use the following instructions to manually install the SCO OpenServer 5.X utility program. 1. Insert the IBM ServeRAID SCO Open Server Boot-Time Loadable (BTLD) Diskette into a diskette drive. 2. Create a directory for the server utility. Type: mkdir /ipsraid 3. Mount the diskette drive. Type: mount /dev/fd /mnt 4. Copy the following file. Type: cp /mnt/ipsraid/new/usr/bin/ipsadm /ipsraid/ipsadm 5. Unmount the diskette drive. Type: umount /mnt 6. To start the server utility to run in the background, type: ./ipsadm & 7. Continue with "Using the Server Utility Programs." Using the Server Utility Programs: You can use command-line parameters to customize the ServeRAID programs. To use command-line parameters, issue the IPSADM command in the following format: IPSADM ... Netfinity 5500 - Type 8660 23