IBM 86607SU Hardware Maintenance Manual - Page 196
Caution, Attention, Slide the replacement fan assembly into the server.
UPC - 087944501329
View all IBM 86607SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 196 highlights
Caution The power cable to the fan should be disconnected whenever the fan assembly is not installed in the server; otherwise, the fan might start turning while you are holding it and the fan blades could injure your fingers. 1. Remove the top cover (see "Top cover removal" on page 262). Attention: To ensure proper system cooling, the top cover should be removed for no more than 30 minutes during this procedure. 2. Determine which fan assembly 2 , 3 , or 5 needs to be replaced by checking the fan LEDs on the diagnostic panel (see "Diagnostics panel LEDs" on page 164). 3. Disconnect the fan power cable 1 from the fan assembly that you are replacing. 4. Turn the quarter-turn fastener 6 for the fan assembly one quarter turn and remove the fan assembly from the server. 5. Slide the replacement fan assembly into the server. (If you are replacing fan assembly 1 3 , make sure the tabs 4 fit into the slots at the bottom of the fan opening in the server.) 6. When you have the fan assembly correctly seated, turn the quarter-turn fastener 6 one quarter turn to secure the fan in the server. 7. Connect the fan power cable 1 to the power connector. 8. Replace the top cover (see "Installing the top cover" on page 155). 188 Netfinity Server HMM