IBM 86607SU Hardware Maintenance Manual - Page 384
Install memory modules in connectors J1, J5, J2, J6, Configuration/Setup program.
UPC - 087944501329
View all IBM 86607SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 384 highlights
Installing memory-modules You install memory-modules on the memory board included in the Processor Upgrade Kit. Notes: 1. Install memory modules in connectors J1, J5, J2, J6, J3, J7, J4, and J8, in that order. (See the illustration on the next page for memory connector locations.) 2. If you mix DIMM sizes, install the largest sized DIMM in connector J1, the next largest sized DIMM in connector J2, and so forth, to enhance memory-module performance. 3. Installing or removing memory modules changes the configuration information in the server. Therefore, after installing or removing a DIMM, you must save the new configuration information in the Configuration/Setup program. When you restart the server, the system displays a message indicating that the memory configuration has changed. Start the Configuration/Setup Utility program and select Save Settings. Refer to the following illustrations of the processor housing and the processor board while you perform the steps in this procedure. 1 Thumbscrew 2 Memory board 3 Memory board handle 376 Netfinity Server HMM