IBM 86607SU Hardware Maintenance Manual - Page 80

3. Start (or restart) the server. If the remote server is currently powered off: a. Select 6 System Power from the main menu. b. Select 4 Power On from the System Power menu. If the server is currently powered on, you must restart the server. You can use selections from the System Power menu or the Boot menu to restart the server in several ways. To restart the server using System Power menu selection: a. Select 6 System Power from the main menu. b. Select 3 Power Off from the System Power menu. c. Once the server has powered off, select 4 Power On to restore power to the server. To restart the server using Boot menu selections: a. Select 7 Boot from the main menu. b. Select either 1 Reboot w/OS Shutdown or 2 Reboot Immediately to restart the server. Note For information on the System Power and Boot menus, see "System Power menu selections" on page 68 and "Boot menu selections" on page 69. 4. After you restart the server, return to the main menu and select Z Start Remote Video. Once you have started Remote Video mode on the system management processor, all textual output generated during POST will be sent to the terminal window. The terminal will also act as a fully-active remote session, enabling you to enter keyboard commands that will be sent to the remote server. In this way, you can enter key commands and key-combinations that access POST operations and utilities such as system setup or the RAID mini-configuration program. When you have finished using Remote Video mode, press Ctrl+R, then press Ctrl+E, and then press Ctrl+T. This will end Remote Video mode and return you to the main menu. 72 Netfinity Server HMM