IBM 86607SU Hardware Maintenance Manual - Page 71

3. Using the MPTS utility program, select the driver from the list and select the Edit button. Note Only one driver instance needs to be loaded for each redundant pair of Ethernet controllers. 4. Change the PermaNet Server Feature keyword to True and specify the Primary and Standby slots that contain the redundant pair. Refer to "System board component locations" on page 255 for the locations and slot numbers of the PCI slots. The integrated controller is located in slot E. 5. To enable the writing of messages to the IBMCOM\LANTRAN.LOG file when a failover occurs: a. Copy the file PCNETOS2.EXE from the root directory of the diskette created by ServerGuide to the hard disk drive. b. Add the following statement to the CONFIG.SYS file: Run=d:\path\PCNETOS2.EXE where d and path are the drive and path to which you copied PCNETOS2.EXE. 6. Restart the server. The failover function is now enabled. Windows NT 1. Add the redundant NIC adapter according to the instructions provided with the adapter and in "Adapters" on page 142. 2. Use ServerGuide to install the AMD PCNet Ethernet Family adapter device driver. 3. From the Windows NT desktop, select Control Panel, then select the Network icon, then the Adapters tab. 4. Highlight one of the adapters that will be in the redundant pair and then select the Properties... button. 5. Check the Grouping box. This will show the possible combinations for redundant pairs. 6. Select the adapter pair you want and then select OK. Note that the integrated Ethernet controller is located at PCI bus 0, slot 14. 7. Select Close to exit from the Network setup. When you restart the server, the failover function will be in effect. If a failover occurs, a message is written to the Windows NT Event Viewer log. If the DMI instrumentation code for the integrated Ethernet controller is active (PCNET.EXE was run), a popup message is generated also. Netfinity 5500 - Type 8660 63