IBM 86607SU Hardware Maintenance Manual - Page 220

2. With the cage nut-clip compressed, push the cage nut-clip out of the square hole. 3. Release the screwdriver pressure on the clip. The cage nut is now loose and can be removed from the square hole. Installing cage nuts: The nuts go toward the inside of the NetBAY3. Make sure you install all the cage nuts at the same level on the mounting rails. 1. Hook one side of the cage-nut clip into the rack-mounting-rail square hole. 2. Hold the cage nut in place and compress the cage-nut clip with a flat screwdriver blade. 3. With the cage-nut clip compressed, push the cage-nut clip into the square hole. 4. Release the screwdriver pressure on the clip. The cage nut is now locked in the square hole. 5i topmar=1p. Installing cantilevered devices: Installing cantilevered devices in a NetBAY3 is similar to installing these devices in a rack enclosure. Cantilevered devices can be installed in the front or rear of the NetBAY3. The devices must be screwed to the NetBAY3 vertical mounting rails. Follow the instructions in the documentation that comes with the device and use the following figure as a guide. 212 Netfinity Server HMM