IBM DTCA-24090 Hard Drive Specifications - Page 76
The Set Features command with Feature register
View all IBM DTCA-24090 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
(*2) Default value on P O R is shown in Figure 45 on page 69. (*3) The Set Features command with Feature register = CCh enables the device to revert these parameters to the power on defaults. (*4) In the case of sleep mode, the device goes to idle mode. In other case, the device does not change current mode. (*5) After reset the Standby timer value, it is set to 109 minutes. (*6) According to the initial power mode selection. 68 OEM Specifications of DTCA-2xxxx 2.5 inch H D D
(*2)
Default value on POR is shown in Figure 45 on page 69.
(*3)
The Set Features command with Feature register =
CCh enables the device to revert these
parameters to the power on defaults.
(*4)
In the case of sleep mode, the device goes to idle mode.
In other case, the device does not
change current mode.
(*5)
After reset the Standby timer value, it is set to 109 minutes.
(*6)
According to the initial power mode selection.
68
OEM Specifications of DTCA-2xxxx 2.5 inch HDD