Icom IC-T70A HD Instruction Manual - Page 38
Memory channel programming
View all Icom IC-T70A HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
6 MEMORY/CALL CHANNELS ■ Memory channel programming q Push [V/M/C] to select the VFO mode. w Set a desired frequency: ➥ Push [BAND] to select a desired band. ➥ Rotate [DIAL] to set a desired frequency. ➥ Push the keypad keys directly to set a desired fre- quency. In this case, setting the band and frequency using [BAND] and [DIAL] are not required. ➥ Set other data (e.g. frequency offset, duplex direction, tone squelch, etc.), if desired. e P ush and hold [S.MW](V/M/C) for 1 sec. to enter the select memory write mode. • 1 short and 1 long beep sounds. • The " " icon and memory channel number blink. r Rotate [DIAL] to select a desired channel. • Call channels (C0, C1), VFO and scan edge channels (0A/0b to 24A/24b), as well as regular memory channels, can be programmed in this way. t Push and hold [S.MW](V/M/C) for 1 sec. to program. • 3 beeps sound. • Memory channel number automatically increases when continuing to push [S.MW](V/M/C) for 1 sec. after programming. NOTE: Push [H/M/L] to cancel the program and exit the select memory write mode before memory programming is finished. [EXAMPLE]: Programming 145.440 MHz into memory channel 11 (a blank channel). [DIAL] Push and hold for 1 sec. Rotate to select channel 11. The VFO mode Enter the select memory write mode. Push and hold for 1 sec. to program. Channel 11 Return to the VFO mode. 31