Icom IC-T70A HD Instruction Manual - Page 50
Scan edges programming
![]() |
View all Icom IC-T70A HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
7 SCAN OPERATION ■ Scan edges programming Scan edges can be programmed in the same manner as memory channels. Scan edges are programmed into scan edge memory channels, 0A/0b to 24A/24b. q Push [V/M/C] to select the VFO mode. w Set a desired frequency: ➥ Push [BAND] to select a desired band. ➥ Rotate [DIAL] to set a desired frequency. ➥ Program different frequencies in "✱A" and "✱b." ➥ Set other data (e.g. frequency offset, duplex direction, tone squelch, etc.), if desired. e P ush and hold [S.MW](V/M/C) for 1 sec. to enter the select memory write mode. • 1 short and 1 long beep sounds. • The " " icon and memory channel number blink. r R otate [DIAL] to select a desired programmed scan edge channel from 0A to 24A. t Push and hold [S.MW](V/M/C) for 1 sec. to program. • 3 beeps sound. • The other scan edge channel "b," 0b to 24b, is automatically selected when continuing to push [S.MW](V/M/C) after programming. y T o program a frequency for the other pair of scan edges, 0b to 24b, repeat steps w and t. • If the same frequency is programmed into a pair of scan edges, programmed scan will not function. [DIAL] [EXAMPLE]: Programming 145.300 MHz into scan edges 3A. Push and hold for 1 sec. Rotate "3A." to select Push and hold for 1 sec. The VFO mode Enter the select memory write mode. Return to the VFO mode. "3A" is selected. 43
![](/manual_guide/products/icom-ict70a-e-instruction-manual-08e11d5/50.png)