Icom IC-T70A HD Instruction Manual - Page 51
Memory scan
![]() |
View all Icom IC-T70A HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
SCAN OPERATION 7 ■ Memory scan IMPORTANT!: To perform a memory scan, 2 or more memory channels MUST be programmed, otherwise the scan will not start. q P ush [V/M/C] repeatedly to select the memory mode. w Set the squelch level. e P ush and hold [SCAN](H/M/L) for 1 sec. to enter the scan type selection mode. r R otate [DIAL] to select a desired scanning type. • "ALL" for all memory scan, "bAnd" for band memory scan, "dUP" (appears only when duplex operation is set) for duplex scan. [DIAL] All memory scan Push and hold for 1 sec. Rotate Duplex scan Band memory scan 1 t Push [SCAN](H/M/L) to start the scan. 2 • The scan pauses when a signal is received. • Rotate [DIAL] to change the scanning direction. This also re- 3 sumes scanning. 4 • Push [V/M/C] to stop the scan. • While continuing to push [SCAN](H/M/L) in step e, rotate 5 [DIAL] to select a desired scanning type, then release the key 6 also starts the scan. 7 8 9 During memory scan 10 11 12 13 14 15 16 17 18 19 44
![](/manual_guide/products/icom-ict70a-e-instruction-manual-08e11d5/51.png)