Icom IC-T70A HD Instruction Manual - Page 82

10 OTHER FUNCTIONS ■ Resetting The display may occasionally display erroneous information (e.g. when first applying power). This may be caused externally by static electricity or by other factors. If this problem occurs, turn power OFF. After waiting a few seconds, turn power ON again. If the problem persists, perform either or both procedures below. • All reset Reset the CPU before operating the transceiver for the first time, or if the internal CPU malfunctions due to static electricity, etc. All reset clears all programming and returns all settings to their factory defaults. D All reset q Push and hold [ ] for 1 sec. to turn power OFF. w While continuing to push [SET], [BAND] and [H/M/L], then turn power ON to reset the CPU. • "CLEAR" appears when resetting the CPU (See the illustration below). D Partial reset q Push and hold [ ] for 1 sec. to turn power OFF. w While continuing to push [H/M/L], then turn power ON to partially reset the transceiver. NOTE: No message appears on the display after the partial reset is done. All reset • Partial reset Use Partial reset if you want to initialize the operating conditions (VFO frequency, VFO settings, set mode contents) without clearing the memory contents. 75 C AUTION: Resetting the CPU returns all programmed contents to their default settings. Partial reset