Intel 2011B Configuration Guide - Page 11

Chapter 2. Extending a Network's Radio Coverage HOST.CDR, FRAME WLAP Manual BSS ID set to MAC address of access point B. WLAP Manual BSS ID set to MAC address of access point A. Host Computer 00:A0:F8:8B:71:45 B Root access point A 00:A0:F8:93:C5:B5 WLAP Priority = 7000 Ethernet Figure 2-2: Wireless AP Network with Two Hops 00:A0:F8:94:C3:64 C Two Hops WLAP Manual BSS ID of A set to its own MAC address. Access Point C RF Configuration .DTIM Interval 10 .BC/MC Q Max 10 .Max Retries (d) 15 .Max Retries (v) 5 .Multicast Mask (d) 09000E00 hex .Multicast Mask (v) 01005E00 hex .Beacon Interval 100 K-us .Accept Broadcast ESSID Disabled .MU Inactivity Timeout 60 min. .Rate Control 11 Mb/s Optional 5.5 Mb/s Optional 2 Mb/s Required 1 Mb/s Required .RTS Threshold 2347 bytes Extended Range 0 mi. WLAP Mode Enabled WLAP Priority 8000 hex WLAP Manual BSS ID 00:A0:F8:8B:71:45 WLAP Hello Time 20 WLAP Max Age 100 WLAP Forward Delay 5 WLAP MU Table Aging Time 240 min. .WEP (Privacy) Disabled .WEP Algorithm 40 bit shared key .Encryption Key ID 1 Encryption Key Maintenance .Short RF Preamble Disabled Tx Power Control Full OK-[CR] Save-[F1] Save All APs-[F2] Cancel-[ESC] Enter the desired WLAP MAC addr, with which this AP is going to associate. Figure 2-3: WLAP Manual BSS ID on Access Point C in 2-Hop Network Configuring Access Point Bridging and Repeating (WLAP Mode) 5