Intel 2011B Configuration Guide - Page 31
Preparing for the RF Link Test, Running the RF Link Test
UPC - 735858150187
View all Intel 2011B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Chapter 6. RF Link Test 6.3 Preparing for the RF Link Test Before attempting to run the RF Link Test, make sure the two access points are configured as shown in 6.1: Basic Setup for the RF Link Test. Also make sure that they are communicating with each other through a wireless connection. Verify the wireless access point operation by looking at the access point's WLAP RF Statistics screen. To do this, press F3 on the RF Statistics screen. With the WLAP RF Statistics screen displayed, verify that the Current State is Functional and the Itf State is being forwarded (FWD) to the MAC address of the remote access point. An example of the WLAP RF Statistics screen is shown in Figure 6-4. Local Access Point Current # WLAP Itf 1 Current State Priority Functional 7000 hex WLAP RF Statistics Root Interface Root Priority Root MAC Addr Root Path Cost 0 7000 hex 00:A0:F8:93:C5:B5 0 Wireless AP Interface Table Itf WLAP Itf Itf Path Designated Designated ID MAC Addr State Cost Root ID Cost WLAP ID Itf ID 8001 00:A0:F8:94:C2:04 FWD 8002 00:00:00:00:00:00 DIS 8003 00:00:00:00:00:00 DIS 8004 00:00:00:00:00:00 DIS 1 700000a0f893C5B5 0 1 700000a0f893C5B5 0 1 700000a0f893C5B5 0 1 700000a0f893C5B5 0 700000a0f893C5B5 700000a0f893C5B5 700000a0f893C5B5 700000a0f893C5B5 8001 8002 8003 8004 Refresh-[F1] Timed-[F2] Previous-[F4] Exit-[ESC] Figure 6-4: Verifying the Wireless AP Operation 6.4 Running the RF Link Test To run the RF Link Test: 1. Set up the two access points as described in the previous section. 2. From the access point Main menu, select Show RF Statistics. Configuring Access Point Bridging and Repeating (WLAP Mode) 25