Intel 2011B Configuration Guide - Page 43

Index A Access point's LED indicators, 8 Antenna alignment procedure, 32 Antenna cable, 31 Antenna mounting, 31 Antenna Selection option, 32 B Backing up root access point, 13 Backup root access point, network, 14 Beacon, 1 Binoculars, 35 BLK, 6 BPDU, 1 Bridge Protocol Data Unit, 1 Bridging operation, verifying, 16 Bridging two Ethernet networks, 16 Broadcast bit, 10, 14 C Channel number, 15 Channel number setting, 15 Channel setting, 15 Client bridge, 29 Compass, 35 Configuration BPDU, 1 Connection Quality Test screen, 23, 26 Connection Quality Test Screen, RF Link Test, 23 Current State, 6 D Directional antennas, 31 Directional antennas, aligning, 30 Directional antennas, coverage, 34 DIS, 6 E Echo test, 8 ESS ID, 1 Ethernet 10BaseT cross-over cable, 19 Ethernet Timeout setting, 14 Ethernet Timeout setting 4, 21 Ethernet Timeout settings 2 and 3, 17 Extended Range setting, 32 Extended Service Set Identifer, 1 Extended Service Set Identifier, 1 Extending radio coverage, 4 F Firmware version, 1 Functional state, 6, 9 FWD, 6 G Global Positioning System, 35 GPS, 35 H Hop, 4 I Itf State, 6 K Known access points, 7 L LED indicators, 8 Link Required, 14 Link Required option, 11 LIS, 6 Low-loss antenna cable, 31 LRN, 6 M MAC address, 4 MAC address of the remote access point, 26 MAC address, lowest, 16 Maximum signal strength, 26 Mobile Units screen, 30 O older access points, 2 Omni-directional antenna, 34 One-hop network, 4 Other equipment, antenna alignment, 35 P PC Card about, 36 PING operation, 8 Preferred MAC address, 10, 14 Priority setting, 2 Probe, 1 Q Quality Test screen, 23 R Radio power control, support, 31 Configuring Access Point Bridging and Repeating (WLAP Mode) 37