Intel SR1670HV Service Guide - Page 51
VGA Controller Setting 3-pin VGA_SW1, DDR3 Voltage Control Setting 4-pin LVDDR3_SEL1, LVDDR3_SEL2
![]() |
UPC - 735858210034
View all Intel SR1670HV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Jumpers, Connectors, and LEDs 5.1.2 VGA Controller Setting (3-pin VGA_SW1) This jumper allows you to enable or disable the onboard VGA controller. Set to pins 1-2 to activate the VGA feature. Figure 60. VGA Controller Setting 5.1.3 DDR3 Voltage Control Setting (4-pin LVDDR3_SEL1, LVDDR3_SEL2) The server board provides DDR3 voltage control jumper blocks for each CPU bank of memory. These jumper blocks change the voltage level supplied to the DIMM bank, and should only be changed when low voltage DDR3 DIMMs are installed. Set to pins 1-2 to select 1.5V BIOS control, pins 2-3 to select 1.2V Force or 3-4 to select 1.35V Force. CAUTION Moving these jumpers from their default position may cause irreparable damage.The use of LV (low voltage) DDR3 DIMMs on this server board is intended for future use only, and will only be supported after Intel has validated their functionality. This document will be updated with full usage information once validation is complete and tested LV DDR3 DIMMs are added to the Tested Memory List for this server board. 36 Intel® Server System SR1670HV Service Guide
![](/manual_guide/products/intel-sr1670hv-service-guide-3ca2ac9/51.png)